Covidien WarmTouch - Figure 12-20 Serial Number Label; Figure 12-21 Cable Tie Mount for Thermistor Cable

Rear Enclosure Replacement
Service Manual 12-25
Figure12-20.Serial Number Label
15. Discard the old rear enclosure.
16. Position the new rear enclosure with the inside facing up.
17. Attach the cable tie mount for the thermistor cable as follows (Figure 12-21):
a. Remove the backing from the mount to expose the adhesive.
b. Position the mount approximately 0.8 cm (1/3 inch) below the handle opening
and no more that 3.8 cm (1 and 1/2 inches) from the right edge of the open-
ing.
c. Press to adhere the mount to the enclosure.
Figure12-21.Cable Tie Mount for Thermistor Cable