Internal Component Replacement (Inside Front Enclosure)
10-30 Service Manual
To replace the battery:
1. Follow the procedure Separating the Front and Rear Enclosures on page 9-2.
2. Using a non-metallic stylus or similar tool, carefully push the battery up from the
bottom of its holder on the UI PCBA until you can grasp the battery and remove it.
Caution:
The institution should follow local governing ordinances and recycling
instructions regarding disposal or recycling of filter and device
components or end of life of the product.
3. Dispose of the battery as required by WEEE Directive.
4. Insert the new battery into the holder with the positive side facing outward (away
from the UI PCBA). Make sure the battery is completely seated in the holder.
5. Follow the procedure Rejoining the Front and Rear Enclosures on page 9-5.
6. Perform the following tests:
a. Power-On Test on page 7-3.
b. Electrical Safety Tests on page 7-14.
To Next Page
Loading...
