Internal Component Replacement (Inside Rear Enclosure)
11-8 Service Manual
10. Position the thermistor cable against the tie mount on the enclosure as shown in
Figure 11-2 on page 11-4. Secure the cable with a cable tie and trim the end of
the cable tie.
11. Connect the thermistor cable to the 2-pin connector at P108 on the Power PCBA
(Figure 11-3 on page 11-5). Make sure that the connector latch engages.
12. Place a cable tie around the thermistor cable and fan cable approximately 10 cm
(4 inches) from the Power PCBA connectors (Figure 11-3 on page 11-5). Trim the
end of the cable tie.
13. Follow the procedure Rejoining the Front and Rear Enclosures on page 9-5.
14. Perform the following tests:
a. Power-On Test on page 7-3.
b. Temperature Accuracy Test on page 7-8.
c. Electrical Safety Tests on page 7-14.
To Next Page
Loading...
