Covidien WarmTouch - Page 9

Service Manual vii
Figures
1 Introduction
Figure 1-1 Serial Number Label on Back of Warming Unit . . . . . . . . . . . .1-9
Figure 1-2 Menu Screen . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1-10
Figure 1-3 System Information Screen . . . . . . . . . . . . . . . . . . . . . . . . . .1-10
2 Product Overview
Figure 2-1 Front View . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2-3
Figure 2-2 Back View . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2-4
Figure 2-3 Operator’s Panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2-5
3 Installation
Figure 3-1 Positioning the Unit for Power Cord Installation . . . . . . . . . . .3-2
Figure 3-2 Power Cord Connection . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3-3
Figure 3-3 Power Cord Wrapped and Secured . . . . . . . . . . . . . . . . . . . .3-4
Figure 3-4 Back View . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3-6
Figure 3-5 Warming Unit Mounted on IV Pole . . . . . . . . . . . . . . . . . . . . .3-7
Figure 3-6 Bed Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3-8
Figure 3-7 Back View . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3-9
Figure 3-8 Cart Mounting Peg and Warming Unit Mounting Hole . . . . .3-10
Figure 3-9 Warming Unit Mounted on Cart . . . . . . . . . . . . . . . . . . . . . .3-11
4 Operation
Figure 4-1 Main Screen at Power-On . . . . . . . . . . . . . . . . . . . . . . . . . . . .4-4
Figure 4-2 Replace Filter Screen at Power-On . . . . . . . . . . . . . . . . . . . . . .4-4
Figure 4-3 Warming System Set to 40°C (Medium) . . . . . . . . . . . . . . . . .4-6
Figure 4-4 Warming System Set to Boost Mode . . . . . . . . . . . . . . . . . . . .4-6
Figure 4-5 Warming System Set to Heat Off . . . . . . . . . . . . . . . . . . . . . .4-7
Figure 4-6 Warming System Set to Ready Mode . . . . . . . . . . . . . . . . . . .4-7
5 Maintenance
Figure 5-1 Replace Filter Screen . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5-4
Figure 5-2 Filter Enclosure and Power Cord Connection . . . . . . . . . . . . . .5-5
Figure 5-3 HEPA Filter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5-6
Figure 5-4 Gasket inside Filter Enclosure . . . . . . . . . . . . . . . . . . . . . . . . .5-7
Figure 5-5 Replace Filter Screen . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5-8
Figure 5-6 Filter Information Screen - Filter Expired . . . . . . . . . . . . . . . . .5-8
Figure 5-7 Main Screen at Power-On . . . . . . . . . . . . . . . . . . . . . . . . . . . .5-9
Figure 5-8 Power Cord Wrapped and Secured . . . . . . . . . . . . . . . . . . . .5-9