FOR-A FA-9520 - Page 221

221
Item
Display
Description
Composite In
Loss
525/60
625/50
BY-PASS
Unknown
Displays the video format of the COMPOSITE input signal.
Displays “Loss” if there is no input signal.
Displays “Unknown” if there is an unsupported input signal.
Displays “BY-PASS” if the function is enabled.
Reference
Loss
525/60
625/50
1080/59i
1080/50i
720/59p
720/50p
1080/23PsF
1080/24PsF
PAL-M
*1
Unknown
Displays the video format of the genlock input signal.
Displays “Loss” if there is no input signal.
Displays “Unknown” if there is an unsupported input signal.
Option A
*2
Loss
525/60
625/50
1080/59i
1080/50i
720/59p
720/50p
1080/23PsF
1080/24PsF
BY-PASS
Unknown
Displays the video format of the Component input signal of
the FA-95AIO installed in option slot A.
Displays “Loss” if there is no input signal.
Displays “Unknown” if there is an unsupported input signal.
Displays “BY-PASS” if the function is enabled.
Option B
*3
Ditto
Displays the video format of the Component input signal of
the FA-95AIO installed in option slot B.
Input Mode
YPbPr
SMPTE
YPbPr
BETACAM
RGB
Y/C
-----
Displays the input signal format of FA-95AIO installed in
option slot A and B.
*1 Shown when PAL-M Mode Set in the 9-4-1 FS1/FS2 Video System is set to Enable, or an input signal
in GENLOCK IN connector is 525/60 or PAL-M signal.
*2 Shown if FA-95AIO is installed in option slot A.
*3 Shown if FA-95AIO is installed in option slot B.
 Video Output Status
Item
Display
Description
SDI Out 1/2
525/60
625/50
1080/59i
1080/50i
720/59p
720/50p
1080/23PsF
1080/24PsF
1080/59p
1080/50p
BY-PASS
Disable
Displays the video format of the SDI1 output signal.
Displays “BY-PASS” if the function is enabled.
Displays “Disable” if there is no signal output.
SDI Out 3/4
Same as above
Displays the video format of the SDI2 output signal.
Displays “BY-PASS” if the function is enabled.
Displays “Disable” if there is no signal output.
Composite Out
525/60
625/50
BY-PASS
Disable
PAL-M
Displays the video format of the COMPOSITE output signal.
Displays “Disable” if there is no signal output.
Displays “PAL-M” if PAL-M Mode Set is enabled in the 9-4-1
FS1/FS2 Video System menu, and the format setting for the
converted output video signal under Composite Output
Setting in the 9-2-10 Output Assign menu is 525/60.