FOR-A FA-9520 - Page 222

222
Option A
*1
525/60
625/50
1080/59i
1080/50i
720/59p
720/50p
1080/23PsF
1080/24PsF
BY-PASS
Disable
Displays the video format of the FA-95AIO output signal in
option slot A.
Displays “Disable” if there is no signal output.
Option B
*2
Ditto
Displays the video format of the FA-95AIO output signal in
option slot B.
Output Mode
YPbPr SMPTE
YPbPr
BETACAM
RGB
Y/C
Displays the output signal format of FA-95AIO installed in
option slots A and B.
See section 9-2-10 “Output Assign” for details on output
signal format settings.
*1 Shown if the FA-95AIO option is installed in option slot A.
*2 Shown if the FA-95AIO option is installed in option slot B.
 Unit Status
Item
Display
Description
Unit Name
FA-9520
Displays the unit name. The default setting is “FA-9520”.
Fan1
Normal
Stopped
Displays the status of Fan1.
Normal: Operating normally.
Stopped: FAN1 has stopped.
Turn the unit power off, and contact your dealer if a
replacement is needed.
Fan2
Normal
Stopped
Displays the status of Fan2.
Normal: Operating normally.
Stopped: FAN2 has stopped.
Turn the unit power off, and contact your dealer if a
replacement is needed.
Power1
*1
Normal
Abnormal
Displays the status of DC Power1.
Normal: The power supply is normal.
Abnormal: DC Power1 has failed.
A power failure has occurred. Although the unit is working
properly, It is recommended that the power supply unit be
replaced. Contact your dealer if a replacement is necessary.
Power2
*1
Normal
Abnormal
Displays the status of DC Power2.
Normal: The power supply is normal.
Abnormal: DC Power2 has failed
A power failure has occurred. Although the unit is working
properly, It is recommended that the power supply unit be
replaced. Contact your dealer if a replacement is necessary.
*1 : Displays “-------” if the optional FA-95PS is not installed.