Icom IC-7100

5
FUNCTIONS FOR RECEIVE
5-13
Meter peak hold function
Appears for 0.5 seconds.
The Meter Peak hold function is set to ON by default,
the peak level of a received signal strength or the out-
put power is displayed for approximately 0.5 seconds.
The function can be turned OFF in the “Meter Peak
Hold” item of the “Display” Set mode. (p. 17-27)
Push q
SET
(C) to enter the Set mode.
Touch the “Meter Peak Hold” item of the “Display” w
Set mode.
Display > Meter Peak Hold
• If the specied item is not displayed, touch [Y] or [Z](D)
one or more times to select the page.
Touch the desired option to turn ON or OFF the Me- e
ter Peak Hold function.
Push r
SET
(C) to exit the Set mode.
L
eft
R
ight
C
enter
D
isplay
The L, R, C or D in the
instructions indicate the
part of the controller.
L: Left side
R: Right side
C: Center bottom
D: Display (Touch screen)
Touch the option
Example: OFF
Push
SET
Touch “Display”
Touch
“Meter Peak Hold”
Previous view