17
SET MODE
17-13
Standby Beep (Default: ON)
DV Set > Standby Beep (Standby Beep)
Turn the standby beep function ON or OFF.
This function sounds a beep after a received signal dis-
appears.
• OFF: Turns the function OFF.
• ON: Turns the function ON to sound a beep.
• ON (to me: High Tone):
Turns the function ON to sound a beep. If the
signal is addressed to your call sign, a high
pitch beep sounds.
NOTE:
• Even if “Beep (Confirmation)” of the Function screen
is OFF, the standby beep sounds.
• The standby beep output level can be set in “Beep
Level” of the Function screen.
Auto Reply (Default: OFF)
DV Set > Auto Reply (Auto Reply)
Set the automatic reply function to ON, OFF or Voice.
This function automatically replies to a call addressed
to your own call sign, even if you are away from the
transceiver.
When “ON” or “Voice” is selected, the automatic reply
function is automatically turned OFF when you push
[PTT].
• OFF: The automatic reply function is OFF.
• ON: Replies with your own call sign. (No audio reply
is sent)
• Voice: Replies with your call sign and any Auto Reply
message recorded on the SD (up to 10 sec-
onds).
If no SD card is inserted or no message is re-
corded, only your call sign is transmitted. The
transmitted audio will be heard from the speak-
er.
DV Data TX (Default: Auto)
DV Set > DV Data TX (DV Data TX)
Select whether to manually or automatically transmit
slow-speed data.
• PTT: Push [PTT] to manually transmit the input data.
• Auto: When data is input from a PC through either the
[USB2] port or [DATA1] jack*, the transceiver
automatically transmits it.
* “USB2 Function” or “DATA1 Function” item must
be set to “DV Data.” (p. 17-25)
Digital Monitor (Default: Auto)
DV Set > Digital Monitor (Digital Monitor)
Select the receive mode when [XFC] is held down in the
DV mode.
• Auto: Receives in the DV mode or the FM mode,
depending on the received signal.
• Digital: Monitors in the DV mode.
• Analog: Monitors in the FM mode.
Digital Repeater Set (Default: ON)
DV Set > Digital Repeater Set (Digital Repeater Set)
Turn the digital repeater setting function ON or OFF.
In any DV mode except for the DR mode, and when ac-
cessing a repeater that has a call sign that is different
than the transceiver’s setting, this function reads the
repeater’s transmit signal and automatically sets the
repeater call sign.
• OFF: Turns the function OFF.
• ON: Automatically sets the repeater call sign.
RX Call Sign Write (Default: OFF)
DV Set > RX Call Sign Write (RX Call Sign Write)
Set the RX call sign automatic write function to Auto
or OFF.
When receiving a call addressed to your own call sign
in any DV mode except for the DR mode, this function
automatically sets the caller station call sign into “UR.”
• OFF: Turns the function OFF.
• Auto: Automatically sets the call sign of the caller sta-
tion into “UR.”
RX Repeater Write (Default: OFF)
DV Set > RX Repeater Write (RX Repeater Write)
Set the repeater call sign automatic write function to
Auto or OFF.
When receiving a call addressed to your own call sign
through a repeater in any DV mode except for the DR
mode, this function automatically sets the call sign of
the repeater into “R1” or “R2.”
• OFF: Turns the function OFF.
• Auto: Automatically sets the call sign of the repeater
into “R1” and/or “R2.”
DV Set mode
To Next Page
Loading...
