9
D-ST
AR OPERA
TION <AD
V
ANCED>
9-29
D New repeater programming
Repeater group selection1.
Push q
(C) to enter the Set mode.
Touch the “Repeater List” item of the “DV Memory” w
Set mode.
DV Memory > Repeater List
• If the specied item is not displayed, touch [∫] or [√](D)
one or more times to select the page
.
• The repeater groups are displayed.
e Touch [∫] or [√](D) to select the desired repeater
group to be programmed.
• The repeater list of the selected repeater group is dis-
played.
r Push
(C).
t Touch [Add](D).
• The “REPEATER LIST EDIT” screen is displayed.
D Required items for the communication cases
Repeater list
contents
Used as
an access
repeater
Used as a
destination
repeater
Used for a
simplex com-
munication
NAME – – –
SUB NAME – – –
CALL SIGN
✔ ✔
This item MUST
be blank.
GW CALL
SIGN
✔
(For Gateway call)
✔
–
GROUP – – –
USE(FROM)
✔
–
✔
FREQUENCY
✔
–
✔
DUP
✔
–
This item MUST
be set to “OFF.”
OFFSET FREQ
✔
– –
POSITION – – –
LATITUDE – – –
LONGITUDE – – –
UTC OFFSET
– – –
☞ Continued on the next page.
* When you want to add a new repeater by editing a pro-
grammed repeater memory contents, select “Edit.” In this
case, after
programming, be sure to
select “<<Add
Write>>.
”
If you select “<<Overwrite>>,” the original repeater pro-
grammed contents are overwritten.
This section describes how to manually program new
repeater into the repeater list.
The required setting items differ, depending on the re-
peater use. Be sure to confirm the required items, as
shown to the right.
NOTE: To program a repeater into the repeater list,
the repeater’s call sign MUST be entered.
Repeater list programming
The L, R, C or D in the
instructions indicate the
part of the controller.
L: Left side
R: Right side
C: Center bottom
D: Display (Touch screen)
Touch
“DV Memory”
Touch
“Repeater List”
Touch “Add”
*
Touch
the repeater
group.
(Example:
11 Japan)
Push
To Next Page
Loading...
