Icom IC-7100

3
BASIC OPERATION
3-14
Setting frequency (Continued)
D Programming the user band edge
When “ON (User)” or “ON (User) & TX Limit” is selected
in the “Band Edge Beep” item, the “User Band Edge”
item appears in the “Function” Set mode.
A total of 30 band edge frequencies can be programmed
in the “User Band Edge” item.
NOTE:
• All frequency ranges are set to default, so you
should delete or change them to add the desired
band edge frequency.
• Program each channel from left to right and each
frequency must be higher than the preceding fre-
quency.
• The frequency that is duplicated, or out of a trans-
mit frequency range, cannot be programmed.
Push q
SET
(C) to enter the Set mode.
Touch the “Band Edge Beep” item of the “Function” w
Set mode.
Function > Band Edge Beep
• If the specied item is not displayed, touch [Y] or [Z](D)
one or more times to select the page.
Touch the “ON (USER)” or “ON (User) & TX Limit” e
option.
Touch the “User Band Edge” item of the “Function” r
Set mode.
Function > User Band Edge
Follow the instructions in the next topics to delete, t
insert, edit, change or reset Band edges.
After you have finished, push y
SET
(C) to exit the Set
mode.
• Deleting a Band edge
Enter the “User Band Edge” screen. q
SET
(C) > Function > User Band Edge
Touch for 1 second the Band edge to be deleted w .
• If the specied band edge is not displayed, touch [Y] or
[Z](D) one or more times to select the page.
Touch “Delete.” e
• The selected Band edge has been deleted, and then re-
turns to the User Band Edge screen.
Touch [ r ](D) or push
MENU
(C) to return to the
“Function” Set screen.
The L, R, C or D in the instructions indicate the
part of the controller.
L: Left side, R: Right side, C: Center bottom
D: Display (Touch screen)
Touch
“Function”
Push
SET
Touch “User
Band Edge”
Touch for 1 sec-
ond the Band
edge to be de-
leted
Touch “Delete”
Example: Deletes the 1.800–1.999999 MHz range
Previous view