Icom IC-7100 - D Using the Gateway CQ (Gateway Call)

8
D-STAR OPERATION <BASIC>
8-16
D Using the “Gateway CQ” (Gateway call)
When “Gateway CQ” is selected in the “TO SELECT”
screen, the repeater to make a gateway CQ call can be
selected from the repeater list.
Example: Making a gateway CQ call to (Japan; Hama-
cho) from the “Hirano” repeater.
Push q
DR
(C) to select the DR mode.
Check whether or not “TO” is selected. w
• If “TO” is not selected, touch the “TO” eld.
Touch the “TO” field. e
• The “TO SELECT” screen appears.
Touch “Gateway CQ.” r
• The “REPEATER GROUP” screen is displayed.
Touch the repeater group where your destination re- t
peater is listed.
• Example: “11: Japan”
Touch the destination repeater. y
• Example: “Hamacho”
• The transceiver returns to the DR mode screen, and
“Hamacho” is displayed in “TO.”
After selecting a repeater, you can select another re-
peater preset in your transceiver by rotating [DIAL] or
[M-CH] (L).
Or, you can select another repeater group by rotating
[BANK] (L).
“Hamacho” is set in “TO.”
Touch the desti-
nation repeater
( Example:
Hamacho)
Touch the re-
peater group
( Example:
“11: Japan”)
“TO” (Destination) setting (Continued)
“TO” is selected.
Touch
“TO.”
Touch
“Gateway CQ.”
L
eft
R
ight
C
enter
D
isplay
The L, R, C or D in the
instructions indicate the
part of the controller.
L: Left side
R: Right side
C: Center bottom
D: Display (Touch screen)
Previous view