12
SCAN OPERATION
12-17
The receive frequency and the operating mode setting
[BANK]/
[M-CH]
When the VFO
frequency is set
as the priority
channel
Select the repeater to receive
(Example: Hirano43)
Select the DR
mode
Touch
“PRIO Watch ON”
Appears while
the priority
scanning
Set the
receive
frequency
in the VFO
mode.
Checks the selected priority channel every 5 seconds,
while receiving a repeater in the DR mode.
Set the priority channel1.
• Using the VFO frequency
q Touch the Memory channel number indication
once or twice to select the VFO mode. (p. 3-4)
w Set the receive frequency and the operating
mode. (p. 3-7, 3-17)
• Using the Memory/Call/Program Scan Edge
channel
q Touch the Memory channel number indica-
tion once or twice to select the Memory mode.
(p. 3-4)
w Rotate [BANK] or [M-CH]
(L) to set the priority
channel.
•
Memory channel, Call channel or Program Scan Edge
channel can be selected as the priority channel.
Select the repeater in the DR mode2.
q Push
(C) to select the DR mode. (p. 3-17)
w Touch “FROM” (Access repeater), if “FROM” is
not selected.
e Rotate the Dial to select the desired repeater.
•
You can select a repeater in the “FROM SELECT” screen
that is displayed after touching the repeater name on
“FROM.”
Start the Priority scan3.
q Push
(D) to open the Quick Menu win-
dow.
w Touch “PRIO Watch ON” to start the Priority
scan.
• The DR mode screen is automatically selected, and
appears.
• To cancel the Priority scan, touch “PRIO Watch OFF”
in the Quick Menu window.
DR mode and a priority channel
The L, R, C or D in the
instructions indicate the
part of the controller.
L: Left side
R: Right side
C: Center bottom
D: Display (Touch screen)
To Next Page
Loading...
