Icom IC-7100 Advanced Instructions

9
D-STAR OPERATION <ADVANCED>
9-42
You can set unnecessary repeaters as scan skip tar-
gets. The selected repeaters are skipped during scan-
ning for faster selection and scanning.
You can set the skip setting to all repeaters in the se-
lected repeater group, or the individual repeater.
When a repeater is specified as a skip target, its
“USE (FROM)” setting is automatically set to “NO.” In
this case, the repeater cannot be selected in “FROM”
(Access repeater).
D Individual skip setting
Push q
SET
(C) to enter the Set mode.
Touch the “Repeater List” item of the “DV Memory” w
Set mode.
DV Memory > Repeater List
• If the specied item is not displayed, touch [∫] or [√](D)
one or more times to select the page
.
• The repeater groups are displayed.
Touch the repeater group that includes the repeater e
you want to set the skip setting on.
• If the specied item is not displayed, touch [∫] or [√](D)
one or more times to select the page
.
Touch the repeater to be skipped during the DR r
mode scan.
Touch the repeater to be skipped for 1 second. t
Touch “SKIP.” y
• “SKIP” appears on the selected repeater.
• Push
QUICK
(C) and select “SKIP” again to cancel the
skip setting.
• When “SKIP All ON” is selected, touch to set all repeaters
in the group as skip targets.
Select the re-
peater to set
the skip setting
Appears
Appears
Select the
repeater group.
Skip setting for the DR mode scan
D Group skip setting
Push q
SET
(C) to enter the Set mode.
Touch the “Repeater List” item of the “DV Memory” w
Set mode.
DV Memory > Repeater List
• If the specied item is not displayed, touch [∫] or [√](D)
one or more times to select the page
.
• The repeater groups are displayed.
Touch the repeater group to be skipped during the e
DR mode scan for 1 second.
Touch “SKIP All ON.” r
• “SKIP” appears on the selected repeater group.
• Push
QUICK
(C) again and select “SKIP All OFF,” then
touch to cancel the skip setting.
Touch
“Repeater List.”
Touch the
repeater for
1 second.
Touch the
repeater group
for 1 second.
Touch “SKIP.”
Touch
“SKIP All ON.”
Previous view

Icom IC-7100 Specifications

General

Supply	13.8 V DC ±15%
Voltage	13.8 V DC
Operating Temperature	-10°C to +60°C
Frequency Coverage	0.030-199.999 MHz, 400-470 MHz
Modes	SSB, CW, AM, FM, DV
Output Power	HF/50MHz: 100W, 144MHz: 50W, 430MHz: 35W
Receiver Type	Superheterodyne
Antenna Connector	SO-239 (HF/50MHz/144MHz), N-type (430MHz)
Weight	Main unit: 2.3 kg
Type	Base/Mobile
Frequency Range TX	1.8–54 MHz, 144–148 MHz, 430–450 MHz
Frequency Range RX	0.030–199.999 MHz, 400–470 MHz
Memories	505
Current Consumption	TX: 22 A, RX: 1.2 A