2
INSTALLATION AND CONNECTIONS
2-6
Required Connections to a Transceiver
[ANT2] 144/430MHz BANDS
CONNECTOR (p. 2-3)
Connect a 50 Ω antenna for the
144/430 MHz frequency bands or
74.8 MHz and above.
IC-7100
[ANT1] HF, 50/70 MHz BANDS
CONNECTOR (P. 2-3)
Connect a 50 Ω antenna for
the HF, 50/70 MHz frequency
bands or below 74.8 MHz.
[DC 13.8V] DC POWER SUPPLY
(P. 2-8)
Use a power
supply with
13.8 V DC
output and a
capacity of
at least 22
Amperes.
PS-126
(Optional)
[MIC] MODULAR MICRO-
PHONE CONNECTOR
(p. 2-5)
As with a microphone connec-
tor of the controller, accepts
the supplied microphone.
[GND] GROUND TERMINAL
(p. 2-2)
Connect this termi-
nal to a station or
vehicle ground to
prevent electrical
shocks, TVI, BCI
and other problems.
STRAIGHT KEY JACK
Plug diameter: 3.5 mm
/
1
⁄8˝
Accepts a straight key or an
external electronic keyer.
Connect to the [MAIN UNIT]
connector of the controller.
(p. 2-4)
To Next Page
Loading...
