19
MAINTENANCE
19-4
Resetting the CPU (Continued)
D All reset
Recommended! ✓
After an All reset, you cannot use the transceiver in the
DR mode because the repeater list will be cleared.
So we recommend you save the programmed data
onto an SD card, or to your PC using the optional clon-
ing software (CS-7100) before doing an All reset.
After the All reset is finished, load or write the saved
data into your transceiver.
Push q
(C) to enter the Set mode.
Touch the “Reset” item of the “Others” Set mode. w
(Others > Reset)
• If the specied item is not displayed, touch [∫] or [√](D)
one or more times to select the page.
Touch “All Reset.” e
When the dialogue appears, touch “NEXT.” r
After reading the displayed message, touch “YES” to t
perform the All reset.
The transceiver displays "ALL RESET," then the All y
reset is completed.
After performing the All reset
All reset clears all programming and returns all settings
to their factory defaults.
Therefore, the repeater list, Memory channel contents,
filter setting and so on will be cleared, so you will need
to reprogram your operating settings.
When you cannot enter the Set mode
If a touch screen operation error or an unexpected op-
eration occurs, you cannot enter the Set mode. In this
case, perform the All reset as described below:
While holding down ➥
(C),
(R) and
(R), push [PWR] (L).
The L, R, C or D in the
instructions indicate the
part of the controller.
L: Left side
R: Right side
C: Center bottom
D: Display (Touch screen)
To Next Page
Loading...
