12
SCAN OPERATION
12-9
Fine programmed scan (VFO mode)
When a signal is received during a Fine programmed
scan, the scanning tuning step is temporarily set to
10 Hz and the scan speed decreases.
Start the programmed scan. q
• Follow steps q through u as described on page 12-8.
While scanning, touch [FINE]( w D) to switch the scan
function between a programmed scan and a Fine
programmed scan.
Touch [PROG]( e D) to cancel the scan.
While Fine programmed scanning
While Programmed scanning
Touch [FINE].
Touch [FINE].
The L, R, C or D in the
instructions indicate the
part of the controller.
L: Left side
R: Right side
C: Center bottom
D: Display (Touch screen)
To Next Page
Loading...
