8
D-STAR OPERATION <BASIC>
8-14
The destination repeater or station must be set to “TO”
when you transmit a call in the DV mode.
You have eight ways to set the destination.
Click the title shown below to jump to the specied
page.
How to switch the repeater group:
When “Local CQ” or “Gateway CQ” is se-
lected, you can switch the repeater group.
While in the DR mode, push ➥
(C), and then touch “Group Select.”
“Hamacho”
repeater is
set in “TO.”
Setting by the Dial
Rotate the Dial or [M-CH] (L) to select the preset
repeater or Your Call Sign that is displayed on the
DR mode screen. (This operation is disabled when
“CQCQCQ” is set.)
Or, rotate [BANK] (L) to select the repeater group.
“TO” (Destination) setting
To make a Local Area CQ call
“Local CQ” setting (p. 8-15)
Set “CQCQCQ” in “TO” (Destination).
To make a Gateway CQ call
“Gateway CQ” setting (p. 8-16)
Select a repeater from the repeater list, if you want
to make a Gateway CQ call.
To make a call to a specific station
“Your Call Sign” setting (p. 8-17)
Select the station call sign in the Your Call Sign
memory.
To select from RX History
Setting from RX History (p. 8-18)
When you receive a call, the repeater or caller sta-
tion data is stored in RX History.
You can select the destination from the record.
To select from TX History
Setting from TX History (p. 8-19)
When you transmit a call, the destination repeater or
called station data is stored in TX History.
You can select the destination from the record.
To directly input the destination station call sign
Direct Input (UR) (p. 8-20)
Directly input the destination station call sign.
To directly input the destination repeater call sign
Direct Input (RPT) (p. 8-21)
Directly input the destination repeater call sign.
[TO SELECT] screen
To Next Page
Loading...
Need help?
General
