19
MAINTENANCE
19-5
Connect a mini plug cable to the [REMOTE] jack of q
the master and sub transceivers.
To [REMOTE]
To [REMOTE]
Mini plug cable
(Purchase separately)
Push [PWR] w (L) to turn ON the power, and then
touch the “Clone” item of the “Others” Set mode.
(
(C) > Others > Clone)
Operate the master transceiver and sub transceiver e
as described below.
Master transceiver’s operation:
Touch the “Clone Master Mode.”
When the dialogue “Go to the Clone Master Mode?”
appears, touch “YES.”
Sub transceiver’s operation:
Touch the “Clone Mode.”
When the dialogue “Go to the Clone Mode?” ap-
pears, touch “YES.”
Touch “OUT” on the master transceiver to start clon- r
ing.
While cloning, the screen as show below is dis-
played.
Master transceiver’s screen:
Sub transceiver’s screen:
When cloning is finished, turn power OFF, then ON t
again to exit the cloning mode.
• “CLONE END” appears automatically on the sub trans-
ceiver’s display after the cloning is completed.
Data cloning
The IC-7100 has data cloning capability.
This function is useful when you want to copy all of the
programmed contents from one IC-7100 to another.
You can clone using an SD card, optional cloning soft-
ware (CS-7100) or a mini plug cable (purchase sepa-
rately).
See page 13-15 for an SD card cloning.
D Cloning between transceivers using a mini plug cable
To Next Page
Loading...
