19
MAINTENANCE
19-3
Resetting the CPU
D Partial reset
Push q
(C) to enter the Set mode.
Touch the “Reset” item of the “Others” Set mode. w
(Others > Reset)
• If the specied item is not displayed, touch [∫] or [√](D)
one or more times to select the page.
Touch “Partial Reset.” e
When the dialogue appears, touch “YES.” r
The transceiver displays "PARTIAL RESET," then t
the partial reset is completed.
If you want to reset the operating parameters to their
default values (VFO frequency, VFO settings, menu
group’s contents) without clearing certain data, a par-
tial reset can be performed as described below.
After performing the partial reset
A Partial reset resets operating settings to their default
values (VFO frequency, VFO settings, menu contents)
without clearing the items listed below:
• Memory channel contents (Section 4)
• Repeater list (p. 9-28)
• Call sign memories (p. 9-45)
• TX Message data (p. 9-2)
• GPS Memory contents (p. 10-7)
• GPS Message data (p. 10-17)
• Programmed user band edge frequencies (p. 3-14)
• Memory keyer contents (p. 4-6)
• DTMF memories (p. 6-17)
• RTTY memories (p. 4-18)
• REF Adj (Reference frequency) setting (p. 17-22)
The L, R, C or D in the
instructions indicate the
part of the controller.
L: Left side
R: Right side
C: Center bottom
D: Display (Touch screen)
To Next Page
Loading...
