Icom IC-7100

10
GPS/GPS-A OPERATION
10-11
Adding or editing GPS memory (Continued)
D GPS group name programming
You can register the name of each GPS group.
Push q
SET
(C) to enter the Set mode.
Touch the “GPS MEMORY” item of the “GPS” Set w
mode.
GPS > GPS Memory
• If the specied item is not displayed, touch [∫] or [√](D)
one or more times to select the page.
Touch the desired group for 1 second to edit between e
group “A” to “Z.”
Touch “Edit Name.” r
• The “GROUP NAME” screen is displayed to edit the
group name.
Enter the name touching the desired block one or t
more times to select the desired character, number
or symbol.
• Touch “AB12” to toggle between the Alphabet input
and number input mode.
• Touch [ [AB] ] and select “ab” to enter the lower case let-
ters.
• Touch [CLR](D) to delete the selected character, symbol
or number.
• Touch “  ” to input a space.
Touch [ y f](D) or [g](D) to move the cursor backward
and forward.
Repeat steps u t and y to program up to 16 charac-
ters of a GPS group name (space included).
Touch [ENT] i
(D) when the programming is completed.
• Returns to the “GPS MEMORY” screen.
The L, R, C or D in the
instructions indicate the
part of the controller.
L: Left side
R: Right side
C: Center bottom
D: Display (Touch screen)
L
eft
R
ight
C
enter
D
isplay
Touch for
1 second.
Name programming
Moves the cursor.
Clears a character.
Character
type selection.
Touch after enter-
ing.
Cancels and
returns to the
previous screen.
Space
Character type selection screen
Touch [ab] to select
the lower case
letters.
Example;
“Point 04”
is entered.
Previous view