Icom IC-7100

9
D-STAR OPERATION <ADVANCED>
9-15
The Auto Reply voice announcement can be recorded
and saved on the SD card to reply to the call with your
voice.
NOTE: Be sure to insert an SD card to the [SD] slot
of the transceiver before starting to record a voice
announcement.
Push q
SET
(C) to enter the Set mode.
Touch the “DV Auto Reply” item of the “Voice Memo” w
Set mode.
Voice Memo > DV Auto Reply
• If the specied item is not displayed, touch [∫] or [√](D)
one or more times to select the page
.
Push [PTT] on the microphone to start recording. e
(No RF is transmitted)
• After releasing [PTT] on the microphone, the recording is
cancelled.
• Maximum record period is 10 second
• Hold the microphone 5 to 10 cm (2 to 4 inches) from your
mouth, then speak into the microphone at a normal voice
level.
• Only one announcement can be recorded. The current
contents will be overwritten if you record again.
Push r
SET
(C) to exit the Set mode.
D Playing back the recorded voice audio
The recorded voice audio for the Auto Reply function can
be played back.
Push q
SET
(C) to enter the Set mode.
Touch the “DV Auto Reply” item of the “Voice Memo” w
Set mode.
Voice Memo > DV Auto Reply
• If the specied item is not displayed, touch [∫] or [√](D)
one or more times to select the page
.
Touch the [ e ≈](D) to start the playback.
Push r
SET
(C) to exit the Set mode.
While playing back
Touch
“[MIC GAIN]”
Automatic Reply function (Continued)
Information ✓
You can delete the recorded audio.
On the DV AUTO REPLY screen, push ➥
QUICK
(C),
and then touch the “Clear.”
Touch
“Voice Memo”
Touch
“DV Auto Re-
ply”
Touch []
While
recording
Audio level is displayed
Adjust the Mic
gain that the
REC Level
does not reach
to this range
Recording time
is displayed
The L, R, C or D in the
instructions indicate the
part of the controller.
L: Left side
R: Right side
C: Center bottom
D: Display (Touch screen)
L
eft
R
ight
C
enter
D
isplay
D Recording an Auto Reply voice announcement
Previous view