Icom IC-7100 - D about the CW Reverse Mode; D about Keying Speed; D about CW Pitch Control

4
RECEIVE AND TRANSMIT
4-4
Operating CW (Continued)
D About the CW reverse mode
The CW reverse mode receives signals with a reverse
side CW carrier point similar to voice LSB and USB
modes.
Use when interfering signals are near a desired signal
and you want to reduce the interfering tone.
On the Mode selection screen, touch “CW” to select q
the CW mode.
After the CW mode is selected, touch “CW” again on w
the Mode selection screen to toggle between CW
and CW-R modes.
• Check that the interfering tone can be reduced.
D About keying speed
The transceiver’s internal electronic keyer speed can
be adjusted to between 6 and 48 wpm (words per min-
ute)
.
Push q
SPEED/PITCH
(C) to open the Key speed/CW pitch
adjustment display.
Rotate [M-CH] w (L) clockwise to increase keying
speed; counterclockwise to decrease it.
Push e
MENU
(C) to close the display.
D About CW pitch control
The received CW audio pitch can be adjusted to suit
your preference without changing the operating fre-
quency.
Push q
SPEED/PITCH
(C) to open the Key speed/CW pitch
adjustment display.
Rotate [BANK] w (L) to suit your preference.
• Adjustable from 300 to 900 Hz (in 5 Hz steps).
Push e
MENU
(C) to close the display.
Key speed adjustment
CW pitch adjustment
Carrier point
The CW carrier point is set to the LSB side by de-
fault, the setting can be changed to USB side in the
“CW Normal Side” item of the “Function” Set mode.
(p. 17-21)
SET
(C) > Function > CW Normal Side
L
eft
R
ight
C
enter
D
isplay
BFO
CW-R mode (USB side)
BFO
Desired signal
CW mode (LSB side)
Interference
Desired signalInterference
The L, R, C or D in the
instructions indicate the
part of the controller.
L: Left side
R: Right side
C: Center bottom
D:
Display (Touch screen)
Previous view