Icom IC-7100 Advanced Instructions

9
D-STAR OPERATION <ADVANCED>
9-6
The L, R, C or D in the
instructions indicate the
part of the controller.
L: Left side
R: Right side
C: Center bottom
D: Display (Touch screen)
L
eft
R
ight
C
enter
D
isplay
Message operation (Continued)
D TX message deleting
The programmed TX message can be deleted, as
described below.
Push q
SET
(C) to enter the Set mode.
Touch the “TX Message” item of the “My Station” Set w
mode.
My Station > TX Message
• If the specied item is not displayed, touch [∫] or [√](D)
one or more times to select the page.
Touch the desired message memory number for 1 e
second.
(Example: 1:)
Touch the “Clear” item. r
• The conrmation screen “Clear?” appears.
Touch [YES]( t D).
Push y
SET
(C) to exit the Set mode.
Touch
“My Station”
Example: To delete the programmed TX message “JAPAN
>TOM” from message memory number 1.
Touch
“TX Message”
Touch the
message
memory for 1
second
(Example: 1:)
Touch
“Clear”
Touch
[YES]
Push
SET
Previous view

Icom IC-7100 Specifications

General

Supply	13.8 V DC ±15%
Voltage	13.8 V DC
Operating Temperature	-10°C to +60°C
Frequency Coverage	0.030-199.999 MHz, 400-470 MHz
Modes	SSB, CW, AM, FM, DV
Output Power	HF/50MHz: 100W, 144MHz: 50W, 430MHz: 35W
Receiver Type	Superheterodyne
Antenna Connector	SO-239 (HF/50MHz/144MHz), N-type (430MHz)
Weight	Main unit: 2.3 kg
Type	Base/Mobile
Frequency Range TX	1.8–54 MHz, 144–148 MHz, 430–450 MHz
Frequency Range RX	0.030–199.999 MHz, 400–470 MHz
Memories	505
Current Consumption	TX: 22 A, RX: 1.2 A