9
D-ST
AR OPERA
TION <AD
V
ANCED>
9-28
You can store repeater information for quick and simple
communication in up to 900 repeater memory channels
(Repeater list) in up to 25 Groups.
Programming the repeater list is required for DR mode
operation.
D Repeater list contents
The following contents are included in the repeater list:
• NAME (Repeater name) (p. 9-30)
• SUB NAME (Repeater sub name) (p. 9-31)
• CALL SIGN (Repeater call sign and port letter)
(p. 9-32)
• GW CALL SIGN (Gateway repeater’s call sign and
port “G”) (p. 9-33)
• GROUP (Repeater group) (p. 9-33)
• USE(FROM) (Access repeater use) (p. 9-34)
• FREQUENCY (Access repeater’s input frequency)*
(p. 9-34)
• DUP (Duplex direction)* (p. 9-35)
• OFFSET FREQ (Frequency offset)* (p. 9-35)
• POSITION (Position data accuracy level) (p. 9-36)
• LATITUDE (Latitude position of the repeater)
(p. 9-36)
• LONGITUDE (Longitude position of the repeater)
(p. 9-36)
• UTC OFFSET (UTC Offset) (p. 9-37)
* Appears only when USE(FROM) is selected as YES.
Example: “Hirano” repeater information
NOTE: For easy operation, the repeater list is pre-
loaded into your transceiver. However, if the CPU
clears all programmed contents (All Reset), the re-
peater list is also cleared. We recommend that mem-
ory data be backed up externally or be saved to a PC
using the optional CS-7100 c l o n i n g s o f t w a r e .
About the repeater list:
The repeater list can be downloaded from the Icom
website.
http://www.icom.co.jp/world/support/download/rm/
index.html
Repeater list
To Next Page
Loading...
Need help?
General
