9
D-ST
AR OPERA
TION <AD
V
ANCED>
9-32
Repeater call sign programming4.
When used for simplex communication, go to
[7. Access repeater setting].
!6 Touch “CALL SIGN” to enter the repeater call sign
edit mode.
• A cursor appears and blinks.
!7 Touch the desired block one or more times to select
the desired character or symbol.
• A to Z, 0 to 9, / and a space can be selected.
• Touch “AB⇔12” to toggle between the Alphabet input
and Number input mode.
• Touch [CLR](D) to delete the selected character, symbol
or number.
• Touch “ ” to input a space.
!8 Touch [f](D) to move the cursor backwards, or
touch [g](D) to move the cursor forwards.
!9 Repeat steps !7 and !8 to enter a call sign of up to 8
characters, including spaces.
@0 After entering the call sign, touch [ENT](D).
Information ✓
Be sure to add a repeater node (port) letter as the 8th
digit in the call sign field after a repeater call sign, ac-
cording to the repeater frequency band, as shown be-
low.
Note that Japanese repeater node letters are different.
1200 MHz: A (B in Japan)
430 MHz: B (A in Japan)
144 MHz: C (no D-STAR repeaters in Japan)
Cross band operation between different nodes at the
same repeater site can be made.
Example:
“JP1YYY A”
☞ Continued on the next page.
Repeater list programming (Continued)
Touch
“CALL SIGN”
Touch [ENT]
The L, R, C or D in the
instructions indicate the
part of the controller.
L: Left side
R: Right side
C: Center bottom
D: Display (Touch screen)
To Next Page
Loading...
Need help?
General
