EasyManuals Logo

Icom IC-7100 Advanced Instructions

Icom IC-7100
375 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #242 background imageLoading...
Page #242 background image
12
SCAN OPERATION
12-3
For a Programmed scan:
Program scan edge frequencies into Program Scan
Edge channels “1A–3A” and “1B–3B. (p. 12-7)
For a Memory scan:
Program two or more Memory channels. (Program
Scan Edge channels will not be scanned.) (p. 11-5)
For a Mode Select scan:
Program two or more Memory channels, all with the
same operating mode. (p. 11-5)
For a Select Memory scan:
Program two or more Memory channels as Select
Memory channels. (p. 11-5)
For a F scan:
Set the F span (F scan range) in the “SCAN” screen.
(p. 12-14)
• Scan Resume function
You can set the scan to resume or cancel when detect-
ing a signal in the Scan Set mode. The Scan Resume
function must be set before starting a scan. (p. 12-5)
• Scan speed
The scan speed can be set to fast or slow in the Scan
Set mode. (p. 12-5)
• Dial function
How the Dial functions during a scan, can be set in the
Scan Set mode. (p. 12-5)
• Squelch status
The scan starts with the squelch open
For a programmed scan:
When the tuning step is 1 kHz or less:
The scan continues until it is manually stopped— it
does not pause*, even if signals are detected.
* The scan is paused when the squelch is closed and then
opened. The scan resumes, or is cancelled, depending on
the Scan Resume setting.
When the tuning step is 5 kHz or more:
If Scan Resume is ON, the scan pauses on each step
when a signal is detected, then resumes.
If the Scan Resume is OFF, the scan does not start.
For memory scan:
If Scan Resume is ON, the scan pauses on each channel
when a signal is detected, then resumes.
If Scan Resume is OFF, the scan does not start.
The scan starts with the squelch closed
The scan pauses when a signal is detected. The scan
resumes, or is cancelled, depending on the Scan Re-
sume setting.
Preparation
Previous view

Table of Contents

Other manuals for Icom IC-7100

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Icom IC-7100 and is the answer not in the manual?

Icom IC-7100 Specifications

General IconGeneral
Supply13.8 V DC ±15%
Voltage13.8 V DC
Operating Temperature-10°C to +60°C
Frequency Coverage0.030-199.999 MHz, 400-470 MHz
ModesSSB, CW, AM, FM, DV
Output PowerHF/50MHz: 100W, 144MHz: 50W, 430MHz: 35W
Receiver TypeSuperheterodyne
Antenna ConnectorSO-239 (HF/50MHz/144MHz), N-type (430MHz)
WeightMain unit: 2.3 kg
TypeBase/Mobile
Frequency Range TX1.8–54 MHz, 144–148 MHz, 430–450 MHz
Frequency Range RX0.030–199.999 MHz, 400–470 MHz
Memories505
Current ConsumptionTX: 22 A, RX: 1.2 A

Related product manuals