19
MAINTENANCE
19-6
Data cloning (Continued)
D Cloning using a cloning software
The optional CS-7100 c l o n i n g s o f t w a r e is also avail-
able to clone/edit contents with a PC using ICF format
files.
The programmed data can be write to the transceiver
using an SD card or a PC.
This section describes how to write the programmed
data to the transceiver using an SD card.
If you want to write the programmed data into the trans-
ceiver using a PC, see the CS-7100 instruction manual
for details.
Save the IC-7100’s setting data onto an SD card. (p. q
13-6)
(
(C) > SD Card > Save Setting)
Start-up the Windows that the CS-7100 is installed. w
Insert the SD card in the PC. e
• Insert the SD card into the SD card slot of the PC or the
SD card reader.
Double-click the CS-7100 shortcut icon on the desk- r
top to start the software.
• After starting up, “Initial Setup” appears the rst time.
• To make the initial setup using the saved data on the
card, follow the steps as described in “Initial setup using
an SD card.” (p. 19-7)
Click “ t ” on the tool bar, or “Open...” in the File
menu to show the data file selection screen. Select
the ICF file, saved in step q, as described above.
Set the desired settings in the CS-7100. y
• Please refer to the Help le of the cloning software for
assistance with the functions or settings.
Click “ u ” on the tool bar, or “Save As...” in the File
menu to save the settings in an “icf” file format in a
[Setting] folder on the card.
Insert the SD card that includes the ICF file into the i
slot of the transceiver.
Load the file to complete the cloning. o
(
(C) > SD Card > Load Setting)
Open
Save
Click
To Next Page
Loading...
