Icom IC-7100 - D Connector Information for the AT-180 ACC(2) Socket; D Specifications for the

16
ANTENNA TUNER OPERATION
16-3
D Connector information for the AT-180 ACC(2) socket
PIN LAYOUT
PIN NO./
NAME
DESCRIPTION SPECIFICATIONS
ACC 2
1
2
3
4
5
6
7
(Rear panel view)
8 V q
Regulated 8 V output when the Band Voltage
modification is performed.
Same as ACC pin q.
GND w Connects to ground.
–
HSEND e
Input/output pin.
Goes to ground when transmitting
When grounded, transmits.
Same as ACC pin e.
NC r No connection.
–
ALC t ALC output voltage
Same as ACC pin y.
NC y No connection.
–
13.8 V u
13.8 V output when power is ON
Same as ACC pin i.
D Specications for the AH-4
Frequency coverage : 7–54 MHz (with an AH-2b)
3.5–54 MHz (with more than
7 meters long wire)
Input impedance : 50 Ω
Maximum input power : 120 W
Minimum tuning power : 10 W (5–15 W)
Tuning accuracy : Less than SWR 2:1
Power supply requirements : 13.8 V DC/1 A (supplied from
the transceiver’s ACC socket)
Dimensions (mm/in) :
172(W) × 69.5(H) × 230(D)
6.7 (W) × 2.7(H) × 9.0(D)
Weight (Approximately) : 1.2 kg; 2.6 lb
Supplied accessories : See the AH-4 instruction
manual
D Specications for the AT-180
Frequency coverage : 1.8–54 MHz
Input impedance : 50 Ω
Maximum input power : 120 W
Minimum tuning power : 8 W
Matching impedance range : 16.7–150 Ω (HF band)
20–125 Ω (50 MHz band)
Tuning accuracy : Less than SWR 1.5:1
Insertion loss : Less than 1.0 dB
(after tuning)
Power supply requirements : 13.8 V DC/1 A (supplied from
the transceiver’s ACC socket)
Dimensions (mm/in) :
167(W) × 58.6(H) × 225(D)
6.6(W) × 2.3(H) × 8.9(D)
Weight (Approximately) : 2.3 kg; 5.1 lb
Supplied accessories : ACC cable (DIN 13 pins)
Coaxial cable (1 m),
Connecting the antenna tuner (Continued)