13
USING AN SD CARD
13-8
The saved memory channels, Set mode item settings
and repeater lists can be copied to the transceiver.
This function is convenient when copying the saved
data, such as memory channels, or repeater lists, to
another IC-7100 and then operating with the same
data.
Saving the current data is recommended before load-
ing other data in the transceiver.
(Example: Loading all the data in the
“Set20130301_01” le)
Push q
(C) to enter the Set mode.
Touch the “Load Setting” item of the “SD Card” Set w
mode.
(SD Card > Load Setting)
• If the specied item is not displayed, touch [∫] or [√](D)
one or more times to select the page.
Touch the desired file to be loaded. e
(Example: Selecting “Set20130301_01”)
• The LOAD FILE screen appears.
Touch the desired loading option, as shown below. r
• ALL:
Loads all memory channels, item settings in the menu
list and the repeater list into the transceiver.
• Select:
Loads all memory channels, Set mode item settings
and the repeater list into the transceiver.
“MY call signs” and “REF Adjust” settings can be se-
lected to be loaded.
• Repeater List Only:
Loads only the repeater list into the transceiver.
The “Keep 'SKIP' settings in Repeater List?” appears. t
Touch [YES], [NO] or [Cancel](D).
• When [YES](D) is touched, the skip settings of the re-
peater list are retained. (p. 9-34)
• When [NO](D) is touched, the skip settings of the re-
peater list are not retained. (p. 9-34)
• When [Cancel](D) is touched, returns to the LOAD FILE
screen.
• When [YES] or [NO](D) is touched, “Load le?” ap-
pears.
To update the repeater list, click
here!
Loading the saved data les that are on the SD card
In the
“SD Card”
screen, touch
“Load Setting.”
The L, R, C or D in the
instructions indicate the
part of the controller.
L: Left side
R: Right side
C: Center bottom
D: Display (Touch screen)
Continued on the next page ☞
To Next Page
Loading...
Need help?
General
