Icom IC-7100

9
D-STAR OPERATION <ADVANCED>
9-34
Repeater list programming (Continued)
Access repeater setting7.
The programmed repeaters can be used as an ac-
cess repeaters in the DR mode.
For simplex operation, or when the programmed
repeater is not used as an access repeater, select
“NO.” In this case, the programmed repeater does
not appear in the “FROM” selection.
@9 Touch “USE(FROM).”
• The “USE(FROM)” screen appears.
#0 Touch “YES.”
• You can select the programmed repeater as an access
repeater (FROM).
Access repeater frequency programming8.
This item appears only when “YES” is selected in
‘7. Access repeater setting.’
#1 Touch “FREQUENCY” to enter the frequency edit
mode.
• A cursor appears and blinks.
#2 Touch the desired number to enter the desired fre-
quency shift.
• Touch [CE](D) to delete the selected number.
• Touch [f](D) to move the cursor backwards, or touch
[g](D) to move the cursor forwards.
* If desired, touch the frequency for 1 second to open the
Function set window, and then touch the “Frequency
Clear” to delete the frequency.
#3 After entering, touch [ENT](D).
☞ Continued on the next page.
The L, R, C or D in the
instructions indicate the
part of the controller.
L: Left side
R: Right side
C: Center bottom
D: Display (Touch screen)
L
eft
R
ight
C
enter
D
isplay
Touch
“USE(FROM)”
Touch
“YES”
Touch
“FREQUENCY”
Example:
“439.340”
Touch [ENT]
Previous view