Icom IC-7100

7
D-STAR INTRODUCTION
7-4
“MY” (Your own call sign) programming
Convenient! ✓
If necessary, enter a note of up to 4 characters, such as
the model of the transceiver, name, area name, and so
on, after your call sign.
Touch [ q g](D) one or more times until the cursor
moves to the right of the “/”.
Repeat steps w t and y on the page 7-3 to enter a
desired 4 character note.
(Example: 7100)
Push
SET
Appears
Touch the entered call sign to set the call sign to be o
used.
!0 Push
SET
(C) to exit the Set mode.
2. Enter the Call Sign (Continued)
L
eft
R
ight
C
enter
D
isplay
Important! ✓
To use a repeater gateway, you must register your call
sign with a gateway repeater, usually one near your
home location.
If needed, ask the gateway repeater administrator for
call sign registration instructions.
Touch the
call sign
( Example:
1:JA3YUA)
The L, R, C or D in the
instructions indicate the
part of the controller.
L: Left side
R: Right side
C: Center bottom
D: Display (Touch screen)
Previous view