21
SPECIFICATIONS AND OPTIONS
21-5
• HM-103 h a n d m i c r o p h o n e
Hand microphone equipped with [UP]/[DOWN] switches.
• HM-151 h a n d m i c r o p h o n e
Remote control microphone.
• HM-198 h a n d m i c r o p h o n e
Hand microphone equipped with [UP]/[DOWN] switches. The
same as that supplied with the transceiver.
• MB-62 m o b i l e m o u n t i n g b r a c k e t
Mounts the transceiver Main unit or the AT-180 under a shelf
board or desk.
• OPC-420 s h i e l d e d c o n t r o l c a b l e
The shielded control cable protects the transceiver from RF
feedback and extends the separation between the AH-4 and
the transceiver up to 10 meters (32.8 feet).
• OPC-589 m i c r o p h o n e a d a p t e r c a b l e
Conversion between 8-pin modular and 8-pin metal connec-
tor for using a desktop microphone.
• OPC-599 a d a p t e r c a b l e
13-pin, ACC connector to 7-pin + 8-pin ACC connector.
• OPC-742 a c c 13-p i n c a b l e
Required when using both of the AT-180 and 144/430MHz
Linear amplifier.
• OPC-1529R d a t a c o m m u n i c a t i o n c a b l e (RS-232C type)
Allows low-speed data communication in the DV mode, and
receiving a GPS data from a third-party GPS receiver.
• OPC-2218LU d a t a c o m m u n i c a t i o n c a b l e (USB type)
Allows low-speed data communication in the DV mode.
• OPC-2253 c o n t r o l c a b l e
• OPC-2254 c o n t r o l c a b l e
OPC-2253: 3.5 m (11.5 ft) type,
OPC-2254: 5 m (16.4 ft) type
• CS-7100 c l o n i n g s o f t w a r e
Use this software to program settings, memory channels
and set mode contents quickly and easily via your PC’s USB
port.
A USB cable is required. (A-Mini B type, supplied with the
transceiver)
• RS-BA1 ip r e m o t e c o n t r o l s o f t w a r e
To remotely control radios using the RS-BA1, BE SURE
that you comply with your local regulations.
Approved Icom optional equipment is designed for
optimal performance when used with an Icom trans-
ceiver.
Icom is not responsible for the destruction or damage
to an Icom transceiver in the event the Icom transceiv-
er is used with equipment that is not manufactured or
approved by Icom.
Options (Continued)
IC-PW1/EURO h f /50 m h z a l l b a n d 1 k w l i n e a r a m p l i f i e r
Full-duty 1 kW linear amplifier including an automatic antenna tuner. Has automatic
tuning and band selection capability. Full break-in (QSK) operation is possible. The
amplifier/power supply unit and the remote control unit are separated. An optional
OPC-599 is required for connection.
To Next Page
Loading...
