3
BASIC OPERATION
3-16
Setting frequency (Continued)
Programming the user band edge (Continued) D
• Changing the Band edge frequencies
Enter the “User Band Edge” screen. q
(C) > Function > User Band Edge
Touch the Band edge to be changed. w
• If the desired Band edge is not displayed, touch [Y] or
[Z](D) one or more times to select the page.
• The frequency entry screen is displayed.
Touch desired numbers to edit the lower edge fre- e
quency, and then touch [ENT](D).
• The cursor moves to the upper frequency entry.
• Touch [t u](D) to toggle the lower or upper frequency
entry.
• Touch [f] or [g](D) to move the cursor left or right.
Touch desired numbers to edit the upper edge fre- r
quency, and then touch [ENT](D).
Touch [ t ](D) or push
(C) to return to the
“Function” Set screen.
• Resetting the Band edges
Enter the “User Band Edge” screen. q
(C) > Function > User Band Edge
Touch any band edges for 1 second. w
Touch “Default.” e
• “Initialize Edges?” is displayed.
Touch [YES]( r D).
• Resets all band edge frequencies to default settings.
• If desired, touch “NO” to cancel resetting.
Touch [ t ](D) or push
(C) to return to the
“Function” Set screen.
The L, R, C or D in the
instructions indicate the
part of the controller.
L: Left side
R: Right side
C: Center bottom
D:
Display (Touch screen)
Touch
“Default”
Touch “YES”
Touch the de-
sired Band edge
Edit the lower
edge frequency,
then touch [ENT]
Edit the upper
edge frequency,
then touch [ENT]
Enter the decimal point
Move the cursor
Move the cursor
Selects upper or
lower edges
Enter
Cancel edit
Delete entering
Example: Change the 7.000–7.300000 MHz range
• The frequency entry screen
To Next Page
Loading...
