Mirion Technologies GEM-5 - Events Data Log

Chapter 5 Parameters Definition
164
Table 10 Faults logged by SERVICE.CSV file
Fault logged in
SERVICE.CSV
Set
Manual
Clear
Auto Clear
Out of Service
Causes
Suggest Krypton Mode
Service
√
√
n/a
AUTO,YES
Suggest Normal Service √ √ n/a AUTO,YES
Cold Side Barrier Fault
√
√
√
AUTO,YES
Cold Side Barrier Failed to
Close
√ √ √ AUTO,YES
Cold Side Barrier Failed to
Open
√
√
√
AUTO,YES
Hot Side Barrier Fault √ √ √ AUTO,YES
Hot Side Barrier Failed to
Close
√
√
√
AUTO,YES
Hot Side Barrier Failed to
Open
√ √ √ AUTO,YES
Security Key Access √ √ √ AUTO,YES
Security Supervisor Access √ √ √ AUTO,YES
UPS
√
n/a
√
WARN
Events Data Log
The Events Data Log (filename M_EVENT[*][*].CSV) summarizes the monitoring
results. The Event Totals Log Period determines the time interval between entries.
The range is from 1 to 1440 minutes (24 hours).
The column headings and associated data format are:
Ready: The number of times the approach sensor has been activated during the
interval.
Monitor: The number of monitoring cycles begun since Monitor History was last
cleared.
Clean: The number of “Clean” results obtained since Monitor History was last
cleared.
Contam: The number of “Contaminated” results since Monitor History was last
cleared.
Clean1: The number of “Clean” results obtained during monitoring in Position 1
since Monitor History was last cleared.
Contam1: The number of “Contaminated” results obtained monitoring in
Position 1 since Monitor History was last cleared.