Appendix Q WebRemote
408 Gem-5 User’s Manual
4. For connection to the dashboard (Remote Status Monitoring), type the
following address in the web browser: HOSTIP/dashboard/dashboard.htm
(where HOSTIP is the IP address assigned to HOST#1 or HOST#2 in section
Installation of WebRemote, Monitor 9.0 (or above), and DashBoard Software
on page 399 and also used in Configuration of Contamination Monitors on
page 402).
Direct Link Access
This section describes the process to connect a remote tablet or PC to a WebRemote
enabled contamination monitor via a direct link (USB to Ethernet). For assistance
with DHCP enabled networks, contact local IT administration.
Use the table below to determine the appropriate connection.
Table 51 Physical Connection Between Devices
Does the Embedded
PC of the Monitor
have a LAN Port
available
Does the PC / Tablet
have a LAN port
available
Resolution
NO NO
USB to Ethernet
Adapter on both
Embedded Monitor PC
and Tablet/PC needed
YES NO
required only on
PC/Tablet
NO YES
required on Embedded
Monitor PC
Note: The USB to Ethernet adapter requires Windows driver installation. Use the
drivers included with SCN WEBREMOTE-SW-KIT or download from the
manufacturer website at http://www.dlink.com/us/en/home-solutions/connect/usb and
locate the appropriate model.
1. Using the table above determine what kind of connection is required. For
example if the LAN port is not available on both the Monitor's Embedded
computer and on the Tablet/PC, then connect a USB to Ethernet adapter to
both the embedded computer, and the Tablet/PC/. Use a LAN cable to make
a connection between both USB to Ethernet adapters.
2. Ensure the devices are on the same LAN as described in How to Assign a
Static IP on page 403.
To Next Page
Loading...
Need help?
General
