Mirion Technologies GEM-5 - Configuration of Contamination Monitors

Appendix Q WebRemote
402 Gem-5 User’s Manual
Figure 166: WebRemote with Active Return to DashBoard Button
To connect to DashBoard remotely (i.e. from a remote web browser) follow
instructions outlined in section LAN Access on page 407 and/or Direct Link Access on
page 408.
Configuration of Contamination Monitors
For DashBoard to recognize the contamination monitor's status, status packets from
the contamination monitor are required to be sent to the Host Monitor (HOST#1 and
HOST#2 if applicable). To send status updates to the Host Monitor (HOST#1), the
contamination monitors require configuration.
On the contamination monitor, open the F3, F9-Data (Network) Transfer screen.
Change the Method field to [TCP/IP (UDP Packets)].
In the IP Address field, change it to the IP address of HOST#1 recorded in section
Installation of WebRemote, Monitor 9.0 (or above), and DashBoard Software on
page 399.
For network configuration which has a second Host Monitor, (HOST#2), Change
Method field, under Send Data Log , to [TCP/IP (UDP Packets)].