DMTA-10040-01EN, Rev. E, February 2018
Chapter 496
USER INFO
Allows you to enter information on the user, job, company, work order,
instrument serial number, etc. The information in USER INFO can easily be
transferred into the NORTEC PC software and used as a header for reports.
CAPTURE MODE
In all modes except conductivity, CAPTURE MODE defines the action performed
by the instrument when the REF SAVE key ( ) is pressed. There are two capture
modes:
— INSTANT: The data on the screen is instantly saved when the key to select
this option is pressed. This is the default mode, which is most commonly
used.
— DELAYED: It is possible to specify a delay (CAPTURE DELAY) for data
saving after the REF SAVE key ( ) is pressed. This feature can help you
correctly place the probe before data is saved; for example, during scanning
operations that require two hands.
CAPTURE DELAY
Specifies the data-saving delay when CAPTURE MODE is set to DELAYED.
4.3.7 Memory Text Editor
The memory text editor appears on the instrument screen when editing the file name
or file text fields. This section provides instructions on how to use this editor to
change the file names and file notes.
The following procedure assumes that the MEM menu key ( ) has already been
pressed, and that the FILE MANAGER menu is displayed (see Figure 4-16 on
page 97).
To use the memory text editor
1. Rotate the knob to highlight the file to be edited.
To Next Page
Loading...
