Olympus nortec 600 - Figure 5-133 the Scan Results for both Fastener Rows

DMTA-10040-01EN, Rev. E, February 2018
Chapter 5214
32. Depending on your requirements, press the DISP menu key ( ) again, and
then select your preferred D ERASE (A key) or PERSIST (B key) values.
33. Press the ALARM menu key ( ), and then set the ALARM 1 (A key) to MIX
POS.
34. Press the ALARM menu key ( ) again, and then set the BOTTOM (C key) to
50 %, the LEFT (D key) to −10 %, and the RIGHT (E key) to 110 %.
35. Press the FULL NEXT key ( ) to toggle to the full-screen mode.
36. Place the probe on position 1, and then perform a final scan of both fastener rows
(see Figure 5-133 on page 214).
Figure 5‑133 The scan results for both fastener rows
To fine-tune the instrument settings
 As desired, set the alarm box parameters, horn, or external horn (louder). For
more details about alarms, see “Alarm Menus” on page 292.
The list of all parameters is shown in Figure 5-134 on page 215.