Olympus nortec 600 - Table 7 NORTEC 600 Remote Commands

DMTA-10040-01EN, Rev. E, February 2018
NORTEC PC Software 311
AS1 Alarm Type 1 R BOX/SWEEP/SECTOR/POLAR
AS2 Alarm Type 2 R BOX/SWEEP/SECTOR/POLAR
AS3 Alarm Type 3 R BOX/SWEEP/SECTOR/POLAR
AUE Auto Erase After Null R/W ON/OFF
BAT Predicted Batt Capacity R 0 100
BATT Predicted Batt Capacity R 0 100
BMP Screenshot X
CAE Conductivity Alarm
Polarity
R/W OFF/POSITIVE/NEGATIVE
CAL Conductivity Alarm
Lower
R/W 1.0 (U.S.
units); 0.6
(Metric units)
109.9 (U.S.
units); 63.8
(Metric units)
CAU Conductivity Alarm
Upper
R/W 1.1 (U.S.
units); 0.6
(Metric units)
110.0 (U.S.
units); 63.8
(Metric units)
CCM Capture Mode R/W REPRESS/CONT
CCP Calibration Point R/W 0 4
CCT Capture Time R/W 2.5 120.0
CCV Calibration Value R 0.9 (U.S.
units); 0.52
(Metric units)
110.0 (U.S.
units); 63.8
(Metric units)
CLD Datalogger Clear X N/A N/A
CLP Datalogger Clear X N/A N/A
CND Conductivity R N/A N/A
CNL Set Continuous Null R/W OFF/0.2Hz/0.5Hz/1.0Hz
CNU Conductivity Units R/W %IACS/MS/m
Table 7 NORTEC 600 remote commands (continued)
Command Description R/W/X
Range/valid strings
Min Max