DMTA-10040-01EN, Rev. E, February 2018
Control Functions 97
2. Press the FULL NEXT key ( ) to navigate to the desired field to be edited: FILE
NAME and/or FILE NOTE.
3. Press the C key.
The memory text editor is activated on the instrument display (see Figure 4-16 on
page 97).
Figure 4‑16 The FILE MANAGER menu’s memory text editor and special buttons
4. Use the knob to select characters, and press the FULL NEXT key ( ) to accept
the characters.
5. After the FILE NAME or FILE NOTE has been edited, press to save the
changes, or press to exit without saving.
By default, the text editor highlights the entire original default file name. If a key is
subsequently pressed, the default file name or file note will be deleted. This is also the
case for a previously edited FILE NAME or FILE NOTE. However, it is possible to
avoid deletion (retain the information) by using the text editor navigations keys or
buttons, as outlined below.
Move cursor left
Clear entire line
Move cursor right
Delete character
To Next Page
Loading...
