DMTA-10040-01EN, Rev. E, February 2018
Chapter 498
The navigation keys or special buttons in the text editor allow you to modify
characters that have been mistakenly chosen, or modify previously entered
information, without the need to retype the entire field (see Figure 4-16 on page 97,
which identifies the special buttons and characters).
To insert a character with the navigation keys
1. Rotate the knob until the forward ( ) or backward ( ) arrow is
highlighted.
2. Repeatedly press the FULL NEXT key ( ) until the cursor is in the correct
location.
3. Use the knob to select characters, and press the FULL NEXT key ( ) to accept
characters.
4. After all the desired characters have been selected, press to accept, or press
(return) to cancel.
To delete a character with the navigation keys
1. Rotate the knob until the forward ( ) or backward ( ) arrow is
highlighted.
2. Repeatedly press the FULL NEXT key ( ) until the cursor is in the correct
location (after the character to be deleted).
3. Use the special deletion button ( ) to delete the character(s).
4. If required, use the knob and the FULL NEXT key ( ) to add new characters.
5. After completing the deletion(s), press to accept, or press (return) to
cancel.
To Next Page
Loading...
