DMTA-10040-01EN, Rev. E, February 2018
Software User Interface 59
Figure 2‑11 Example of VMAX
2.4.1 Enabling Real-Time Readings on the Main Inspection Screen
The real-time readings are enabled through the ADV SETUP menu key ( ).
To enable the real-time readings bar on the main inspection screen
1. Press the ADV SETUP menu key ( ).
2. Press the B key.
3. Press the E key.
4. Press the B key.
5. Press the FULL NEXT key ( ) to navigate to the desired type and/or location.
Only TOP LEFT and TOP RIGHT are valid locations for the real-time readings on the
main inspection screen. For available locations in full screen, see “Enabling the Real-
Time Readings in Full-Screen Mode — FULL NEXT key” on page 60.
6. Rotate the knob to make a selection.
7. Press the FULL NEXT key ( ) to navigate to another type and/or location.
To Next Page
Loading...
