DMTA-10040-01EN, Rev. E, February 2018
Chapter 6318
6.7 Remotely Controlling the NORTEC 600 from a PC
You can use the NORTEC PC Remote Control function to remotely control the
NORTEC 600. This is especially useful when the equipment is being used in hot cell
areas (shielded nuclear radiation containment chambers) or for training purposes.
To enable the NORTEC PC remote control function
1. Click Remote Control in the Device menu (see Figure 6-17 on page 309).
The software’s Remote Command dialog box will display an image of the front
face of the NORTEC 600, including its control buttons and display (see
Figure 6-19 on page 319).
2. Control the instrument in much the same way as you would if it were in front of
you.
To display the instrument screen, you must first click Refresh Screen in the Remote
Command dialog box (see Figure 6-19 on page 319). For simultaneous setting
verification, use the instrument display or an external monitor.
YR. Year R/W 2013 2100
Table 7 NORTEC 600 remote commands (continued)
Command Description R/W/X
Range/valid strings
Min Max
To Next Page
Loading...
