DMTA-10040-01EN, Rev. E, February 2018
Chapter 128
The NORTEC 600 charger/adaptor (P/N: EP-MCA-X) is designed to power the
NORTEC 600 and charge the lithium-ion battery only (P/N: 600-BAT-L-2 [U8760058]).
Do not attempt to charge any other types of batteries, including alkaline batteries in
the battery holder (P/N: 600-BAT-AA [U8780295]), and do not attempt to use any
other charger/adaptor. Doing so might cause an explosion or injury.
Do not attempt to power or charge other electronic equipment with the
charger/adaptor (P/N: EP-MCA-X), unless specifically instructed in the manual.
Misuse of the charger/adaptor can cause other batteries and/or instruments to
explode, which could lead to serious injury or death.
To connect the charger/adaptor
1. Connect the AC power cord to the charger/adaptor and to an appropriate power
outlet (see Figure 1-8 on page 28).
Figure 1‑8 Connecting the charger/adaptor
To power outlet
DC power connector
EP-MCA-X
charger/adaptor
AC power cord
To Next Page
Loading...
