DMTA-10040-01EN, Rev. E, February 2018
Chapter 6302
Copy the image to the PC clipboard.
OR
Save the image to the PC hard drive or other memory device.
6.3 Upgrading the Instrument Software Using NORTEC PC
You are able to upgrade the NORTEC 600 instrument’s software using NORTEC PC.
The software upgrade must first be downloaded via the internet or other means and
then saved to a file location on the PC.
To upgrade the NORTEC 600 instrument software
1. Connect the PC to the instrument using a USB cable.
2. Press the ADV SETUP menu key ( ) twice.
3. Press the D key to open the ABOUT menu (see Figure 6-8 on page 302).
Figure 6‑8 The ABOUT menu
4. Press the C key to select UPGRADE (see Figure 6-9 on page 303).
To Next Page
Loading...
