DMTA-10040-01EN, Rev. E, February 2018
NORTEC PC Software 307
After completing the upgrade through the microSD card, the NORTEC 600 shuts
down automatically.
11. After the NORTEC 600 instrument has shut down, turn it on again.
12. Press the ADV SETUP menu key ( ) twice.
13. Press the E key to open the RESET menu.
14. Use the knob to select MASTER RESET.
15. Press the A key to select RUN RESET.
16. Turn off the instrument.
6.5 Creating a PDF
NORTEC PC enables you to export inspection reports to a PC hard drive or memory
device. You can either create an individual PDF file from selected data, or export all
data as a series of PDF files.
If you select the Export All Files As Adobe Acrobat (PDF) option, all stored data on
the NORTEC 600 instrument is automatically selected and used to create individual
PDF files that are saved in a specified location. At the end of this process, the
individual PDF files may be reviewed and printed using Adobe Acrobat or equivalent
software. It is important to choose the destination folder (to which the files are to be
exported) before exporting data in a PDF file.
To create a single PDF file from selected data
Select the file in the left pane of the NORTEC PC window (see Figure 6-14 on
page 307), and then select Export As > PDF (see Figure 6-15 on page 308)
Figure 6‑14 Files in the left pane of the NORTEC PC window
To Next Page
