Olympus nortec 600 - Figure 5-88 Using H POS to Create a Horizontal Mark; Figure 5-89 Creating more Horizontal Marks

DMTA-10040-01EN, Rev. E, February 2018
Chapter 5184
9. Press the DISP menu key ( ), and then, while holding the probe on the three
business cards, adjust the H POS (D key) to 0%, then up to 100 %, and back
down to 50 %.
A horizontal mark is created (see Figure 5-88 on page 184).
Figure 5‑88 Using H POS to create a horizontal mark
10. Repeat step 9 using two business cards, and then again using one business card to
create more horizontal marks (see Figure 5-89 on page 184).
Figure 5‑89 Creating more horizontal marks