Olympus nortec 600 - Figure 5-102 Adjusting the Angle of the Frequency 2 Lift-Off Signal; Figure 5-103 Position 2 on the Standard

DMTA-10040-01EN, Rev. E, February 2018
Chapter 5194
Figure 5‑102 Adjusting the angle of the frequency 2 lift‑off signal
6. Place the probe on position 1, and then press the A-LIFT NULL key ( ).
7. Place the probe on position 2 (see Figure 5-103 on page 194), and then press the
FREEZE key ( ).
Figure 5‑103 Position 2 on the standard
An example of the resulting frozen signals is shown in Figure 5-104 on page 195.