DMTA-10040-01EN, Rev. E, February 2018
Initial Setup 67
Reducing the display BRIGHTNESS percentage increases the battery life. Battery life
specifications are based on backlight BRIGHTNESS set to 50 %.
3.6 Adjusting Auto Erase
You can adjust the NORTEC 600 to clear (erase) the screen contents automatically
after the NULL key is pressed. By default, the AUTO ERASE function is set to ON,
but it can be disabled by selecting OFF.
To adjust Auto Erase
1. Press the ADV SETUP menu key ( ) twice, then press the B key to enter the
SYSTEM SETUP screen.
2. Repeatedly press the FULL NEXT key ( ) until AUTO ERASE is highlighted.
3. Use the knob to disable the function (select OFF) or enable the function (select
ON).
4. Press to return to the previous screen.
3.7 Selecting the Startup Screen
You can adjust the NORTEC 600 to display the APPLICATION SELECTION screen
automatically after it is turned on. This function can also be disabled, so that the
instrument will instead display the main inspection screen. By default, the
APPLICATION WINDOW AT STARTUP function is set to ON.
To select the startup screen
1. Press the ADV SETUP menu key ( ) twice, then press the B key to enter the
SYSTEM SETUP screen.
To Next Page
Loading...
