DMTA-10040-01EN, Rev. E, February 2018
Using the Instrument 153
Figure 5‑45 Using the vertical reference marks for thickness evaluation
To fine-tune the instrument settings
Refer to the list of all parameters, shown in Figure 5-46 on page 153.
The default setting for the reading type (RDG1 TYP) is VMAX, which uses the
vertical maximum amplitude. For this procedure, however, it is recommended to
select HMAX, which uses the horizontal maximum amplitude. For more details
about the reading type or position in the impedance plane display, see
“Displaying Real-Time Readings” on page 56.
Figure 5‑46 The list of all parameters
To Next Page
Loading...
